Components - Kenwood KRF-X9070D Manuel D'instructions

Basic remote control operations for other components
Storing the remote control code of the other

components

The remote control unit can store the remote control code of the other
components and you can operate the other components from the remote
control unit. The remote control code is stored on the key or memory of
the remote control unit.
Storing on the key
You can store the remote control code to the key as shown below:
LCD
VID1
Source keys
VID2
PHONO
SRC Power
Numeric keys
2
Return
Disc Skip
Disc Sel.
Disc Sel.
Input Sel.
¢
CH +/–
Skip ¢/4
4
¡Rewind
1Fast forward
3/8Play/Pause
2Info/Flip
Listen Mode
1
Point the infrared ray system part of another remote control
unit to the remote sensor of the remote control unit.
2
Press and hold the Learn key for 3 seconds until
twice, then release the Learn key.
3
Press the numeric key to enter "9-7-5".
4
Press any of the source keys (PHONO, VID1, VID2, VID3, DVD/
6CH, AV AUX, CD/DVD, MD/TAPE, TV ) to select the input of the
desired remote control unit.
• While in Tuner mode, learning code function will not be available.
5
Press the desired key of the remote control unit.
• "LEARN" appears on the display.
DVD
CD
TUNER
6CH
DVD
MD
VID3 AV AUX
TAPE
TV
POWER
RCVR
4 5
3 6
Multi
7
Enter
Multi
Last / AB
1 8
Page∞/5
0 9
+ 10 + 100
RDS Disp. PTY TV Mute
Page
OSD
Return OSD
Last / AB
Exit Guide
Menu
Disc Skip Menu
Mute
+ +
Tone
CH VOL
Sound
– –
– +
Bass
TV
TV Input
Boost
VOL
Tune – Band Tune +
Dimmer Auto Top Menu
Setup
Info / Flip
Loudness
7Stop
Speaker
DSP Stereo
EQ
Mode
Learn
Input
Active
THX
Mode
EQ
Remote control
unit of the other
source.
Infrared ray system part
6
From the remote control unit of the other source, press the key
that you want to store.
• The remote control code is sent to the remote control unit.
• "OK" appears when finished.
• If the code cannot be stored after a few attempts, "ERROR" will
appear. Repeat from step 2 onwards.
7
The remote control code is stored on the key of this remote
control unit.
8
Repeat step 4 or 6 to store additional components until all
the desired components are stored.
9
To exit the learning mode, press and hold the Learn key for 3
seconds until
0
To clear the stored remote control code of the other sources:
1 Press and hold the Learn key for 3 seconds until
then release the Learn key.
2 Press the numeric key to enter "9-7-6".
3 Press the Source key, then press the stored key twice until
blinks twice.
•
blinks twice to indicate that the stored remote control code are
deleted.
blinks
blinks twice.
blinks twice,
41
EN