Operating By Remote Control; Led Display - Napoleon EFL32H Instructions D'installation Et D'utilisation

5.3

OPERATING BY REMOTE CONTROL

NOTE: Make certain the batteries are installed correctly, for installation
instructions review "REMOTE BATTERY INSTALLATION" section.
NOTE: The heating and fl ame operation may not work immediately if you use
in a cold temperature environment (below 5°C). The unit will warm up and
operate normally after 30 minutes of continuous operating.
A. Make certain the appliance's main power switch is at the ON position.
The remote control will NOT work if the Main Power Switch is at the OFF
position.
B. When operating the remote control, it must be directed towards the front
center of the appliance.
C. The power button can be used to power up or down the appliance (the
main power switch on the appliance must be in the ON position for the
remote to operate). Pressing this button
appliance.
D. To activate the heater, press the fan/heater button
control panel will illuminate. Press and release the function button to cycle
through the settings:
• Press the function button once to turn on the fan only.
• Twice to turn on the fan and the heater on at a low setting (750W).
• Three times to turn on the fan and the heater on at a high setting (1500W).
• Four times to turn both the fan and heater off.
E. To adjust the fl ame height and ember bed brightness, press the fl ame button
brightness levels to cycle through and then an off setting. Every time the fl ame is initiated it will start at
the brightest level.
F. To begin the thermostat function press the thermostat button
illuminate, there are 5 settings. To change to the desired temperature format press and hold the
thermostat button, this will change the display from Celsius to Fahrenheit, or vice versa.
G. Once you have selected the desired temperature the heater will automatically adjust to a high setting
until that temperature is reached.
H. To turn off the thermostat function press the fan/heater button
the icons will illuminate and then the icons will darken.
I. To activate the timer control press the timer button
on the LED display. To choose the desired time continue to press the timer button, there are six
settings, these will appear on the LED display, each setting represents hours of operation.
J. To turn off the timer function press the timer button 6 times, it will cycle through the six different timer
options on the LED display. Press the timer button one more time, this will turn the function off, the
timer icon will darken indicating the function is "OFF".
K. To turn off the appliance, press the power button once.
NOTE: This hand held remote control must remain within 8 meters or 26 feet of the appliance to be
effective.
MODEL EFC32H
FRONT PANEL
activates the power to the
. the icon on the
,the icon on the control panel will
once, you will hear a "BEEP" and all
, the icon will illuminate and the time will appear

LED DISPLAY

13
. There are three
W415-1139 / E / 03.16.15
EN