Finishing; Glass Ember Installation; Glass Front Installation - Napoleon EFL32H Instructions D'installation Et D'utilisation

4.0 FINISHING

POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.1

GLASS EMBER INSTALLATION

Glass front must be removed and the appliance must be mounted in its fi nal location before the glass embers
are installed.
Glass embers may have sharp edges, wear safety glasses and gloves
when handling.
A. CLEAN GLASS MEDIA: Glass media may have a fi ne oil residue
that needs to be cleaned prior to installation. Clean the glass with
mild dish soap, drain, rinse thoroughly and dry before placing into
the tray.
B. Carefully place glass embers into the bottom tray on the front of the appliance as illustrated. Apply an
even layer from side to side.
NOTE: It is not necessary to use all of the glass media supplied.
4.2

GLASS FRONT INSTALLATION

It is recommended that two people install this glass front onto the appliance,
Wear safety glasses and gloves when handling glass.
A. Line up the brackets on the back of the glass with the 4 shoulder
screws on the side of the appliance body.
B. Slide the glass in and downwards, ensuring the bracket has
engaged to the shoulder screw prior to releasing the glass.
WARNING
!
RECONSTRUCTION.
11
Shoulder
Screw
W415-1139 / E / 03.16.15
EN