Hard Wire Installation - Napoleon EFL32H Instructions D'installation Et D'utilisation

6.2

HARD WIRE INSTALLATION

TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED SERVICE
If it is necessary to hard wire the appliance, a qualifi ed electrician may remove the cord connection, and wire
the appliance directly to the household wiring.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired. In
the absence of local codes, the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the current
ANSI/NFPA 70 NATIONAL ELECTRIC CODE in the United States.
Fig. 1
A. Remove the cover plate from the right side of
the appliance by removing the two screws, as
shown in Figure 1.
B. Remove the wire connectors from the power
cord. The power cord may be discarded.
Refer to Figure 3.
C. Take the new cover plate, supplied in the
manual bag. Punch out the 7/8" hole and
install a box connector through, into the
junction box. Snap the box connector clamp
onto the supply wires.
NOTE: Leave enough wire so that the appliance can be removed from the enclosure without
disconnecting the power supply.
!
PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
WARNING
Fig. 2
D. Using the wire connectors, connect the
common white wires (W) together, then the
hot black wires (B), and then the ground
green wires (G), refer to Figure 3.
E. Reinstall the new cover plate as illustrated in
Figure 2.
G
B
W
Fig. 3
W415-1139 / E / 03.16.15
15
EN