Operating Instructions; Main Power Switch; Operating By Remote Control - Napoleon EFL42 Instructions D'installation Et D'opération

5.0 OPERATING INSTRUCTIONS

Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, when the main power switch of the appliance is in the "I" ON position and the hand held remote
control is in the OFF position, the fl ame generation lights will come back on at the high setting, when
the power supply returns.
5.1

MAIN POWER SWITCH

The Main Power Switch is located on the right side of the appliance as illustrated.
The "|" indicates ON and "O" indicates OFF. Push the switch to "|" to turn
on the appliance and the fl ame effect.
5.2

OPERATING BY REMOTE CONTROL

NOTE: Make certain new batteries are installed correctly.
A. Plug in your electric appliance.
B. Make certain the appliance's Main Power Switch is at the ON position! The remote control will NOT
work if the Main Power Switch is at the OFF position.
C. When operating the remote control, it must be directed towards the front center
of the appliance.
D. The button at the top left of the remote can be used to power up or down the
appliance (the main power switch on the appliance must be in the ON position for
the remote to operate). Pressing this button activates the power to the appliance.
E. To activate fl ame, press the "FLAME"
height press the "
F. To activate the heater, press the "HEAT"
will be set for high heat, to adjust the heat level choose the
heat (1500W) or
temperature press the "ROOM TEMP"
temperature is below 21°C. the heater will turn off when the room temperature is
above 25°C.
G. To adjust the blue fl ame press the "
levels of fl ame effects.
H. To turn off the appliance, press the button
NOTE: This remote control must remain within 8 meters or 26 feet of the appliance to be
effective and this range may be reduced as the battery power is depleted.
button and then to adjust the fl ame
+5" or " -5" buttons. There are fi ve levels of fl ame effects.
button for low heat (750W). Adjusting to auto control by room
button, the heater turns on when room
+5" or "
once.
POWER
SWITCH
button. The initial set-up heat level
button for high
-5" buttons. There are fi ve
11
EN
W415-1179 / 01.15.13