Operating By Remote Control - Napoleon Ascent Electric Serie Manuel D'installation Et D'utilisation

4.2

operating by remote control

WARNING
!
• To avoid danger of suffocation, keep the packaging bag away from babies and children.
• Do not use in cribs, beds, carriages, or play pens.
• This bag is not a toy.
• Knot before throwing away.
note:
When operating the remote control, it must be directed towards the front center of the appliance.
The power button can be used to turn the appliance on/off. Pressing
A.
this button
button again will turn off the appliance. The ember and log will fade 4
seconds after turning off the appliance.
To adjust the flame brightness and ember log light, press the flame
B.
button . There is 1 ember log light and 3 flame brightness levels to
cycle through and then an off setting ( LL, F1, F2, F3 and then F0).F3 is
the brightest flame level, LL is the ember log light only.
To control the thermostat function, press the thermostat button
C.
There are 7 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F 85°F and
off). The default setting will display Fahrenheit. Press the thermostat
button to cycle through the settings. Once you have selected the
desired temperature, the heater will automatically operate until that
temperature is reached. When the room temperature is 2 degrees lower
than the temperature setting, the heater will turn on.
To activate the heater and blower, press the heater button
D.
blower will turn on. Press the heater button again to turn on the heater
and blower. Press the heater button again to turn off the heater and
blower.
The timer controls all operating modes of the appliance. To activate
E.
the timer, press the timer button
continue to press the timer button. There are 8 settings (30mins,1h, 2h,
3h, 4h, 5h, 6h and off). The appliance will turn off at the setting time.
To activate the decoration light, press the light button
F.
an off setting (d1, d2, d3 and then d0). d1 white colour, d2 colour cycles from White / Orange / Blue /
Orange-Blue / White-Orange / White-Blue. It will take 8.5 seconds to switch from 1 colour to the next
when in d2 setting and d3 will lock to a desired colour.
To turn off the appliance, press the power button once on the remote, or press the power button once on
G.
the control panel on the appliance.
note:
This hand held remote control must remain within 6 meters (19ft.) of the appliance to be effective.
activates the power to the appliance. Pressing the power
. To choose the desired time,
operating instructions
.
, the
.There are 3 settings to cycle through and then
EN
19
W415-2165 / G / 08.15.18