Operating Instructions; Main Power Switch; Operating By Control Panel (Excluding Model Efc32H) - Napoleon EFL32H Instructions D'installation Et D'utilisation

12

5.0 OPERATING INSTRUCTIONS

Once the appliance has been plugged in to a grounded electrical outlet, it is ready to operate. NOTE: Ensure the
house circuit breakers for the power supply are turned on. In the event of a power failure, the fl ame will
EN
return to a high setting when the power is restored.
NOTE: The heating and fl ame operation may not work immediately if you use in a cold temperature
environment (below 5°C). The unit will warm up and operate normally after 30 minutes of continuous
operating.
5.1

MAIN POWER SWITCH

The main power switch is located on the bottom right hand side of the appliance.
The "|" indicates ON and "O" indicates OFF. Push the switch to "|" to turn on the appliance.
5.2

OPERATING BY CONTROL PANEL (EXCLUDING MODEL EFC32H)

A. Make certain the appliance's main power switch is at the ON position.
B. To activate the heater, press the fan/heater button
through the settings:
• Press the function button once to turn on the fan only.
• Twice to turn on the fan and the heater on at a low setting (750W).
• Three times to turn on the fan and the heater on at a high setting (1500W).
• Four times to turn both the fan and heater off.
C. To adjust the fl ame height and ember bed brightness, press the fl ame button
brightness levels to cycle through and then an off setting. Every time the fl ame is initiated it will start at
the brightest level.
D. To begin the thermostat function press the thermostat button
temperature will appear on the LED display, there are 5 settings. To change to the desired temperature
format press and hold the thermostat button, this will change the display from Celsius to Fahrenheit, or
vice versa.
E. Once you have selected the desired temperature the heater will automatically adjust to a high setting
until that temperature is reached.
F. To turn off the thermostat function press the fan/heater button
the icons will illuminate and then the icons will darken.
G. To activate the timer control press the timer button
on the LED display. To choose the desired time continue to press the timer button, there are six
settings, these will appear on the LED display, each setting represents hours of operation.
H. To turn off the timer function press the timer button six times, it will cycle through the six different timer
options on the LED display. Press the timer button one more time, this will turn the function off, the
timer icon will darken indicating the function is "OFF".
I. To turn off the appliance, switch the main power switch to OFF.
NOTE: THE EFC32H IS NOT EQUIPPED WITH A CONTROL PANEL. PLEASE REFER TO THE
"OPERATING BY REMOTE CONTROL SECTION" FOR INSTRUCTIONS.
W415-1139 / E / 03.16.15
. Press and release the function button to cycle
, the icon will illuminate and the
once, you will hear a "BEEP" and all
, the icon will illuminate and the time will appear
FAN/HEATER THERMOSTAT
FLAME
MODELS EFL32H, EFL48H, EFL60H AND
EFL72H FRONT CONTROL PANEL.
. There are three
LED DISPLAY
TIMER