Remote Control Procedures - Emerson HIGHPOINTE LED CF205LBQ0 Mode D'emploi

8.3: Setting Operating
Frequency of Remote Control
Remove the Battery Cover by pressing firmly below
the arrow and sliding the Cover off the Control
(Figure 36).
Your Remote Control has Code Switches which must
be set in one of 32 possible code combinations.
The five levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up) position. Change
the Switch settings as follows:
Slide the five Switch Levers in the Remote Control to your
choice of ON (up) or down positions. Use a ball-point
pen or small screwdriver and slide the Levers firmly up or
down (Figure 36).
The sixth Switch marked ON and I is for dimming control
of lights: Set Switch to ON to allow for dimming of the
lights. Set Switch to I for no dimming of the lights such as
for fluorescent bulbs.

8. Remote Control Procedures

When the switch is turned back ON the light and fan will
resume operation as they were prior to the switch being
turned OFF.
Figure 35
BATTERY
COMPARTMENT
COVER
Figure 36
NOTE: If your Fan and Light go on and off without
using your Control, you may be getting interference
from other remote units such as garage door
openers, car alarms or security systems.
To remedy this situations, simply change the
combination code in your Remote Control Transmitter.
22
REMOTE CONTROL
LEVERS
ON
1
2 3 4 5 I
CODE
SWITCHES
REMOTE CONTROL
U.L. Model No.: CF205L-1