Remote Control Procedures; Installation Of Batteries - Emerson CURVA SKY CF145LBS00 Manuel Du Propriétaire

8.1: Preset Memory Feature
Your Emerson receiver is equipped with a preset memory
feature. If the AC supply to the receiver is powered
through a wall switch, when the switch is turned OFF,
the control will remember the light intensity and fan speed.

8.2: Installation of Batteries

The Remote Control Transmitter is powered by two AAA
Alkaline Batteries (not included).
To prevent possible battery leakage damage, be sure to
remove the Batteries when the Remote Control is not to
be used for an extended period of time.
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Remote Control.
Install two new AAA Alkaline Batteries into the Battery
Compartment following the correct battery placement
printed on the Compartment (Figure 24).
NOTE: Never use old and new Batteries together in
unit.
Replace the Battery Compartment Cover by sliding the
Cover back onto the Remote Control.
8.3: Setting Operating Frequency
of Remote Control
Remove the Battery Cover by pressing firmly below the
arrow and sliding the Cover off the Remote Control
(Figure 25).
Your Remote Control has Code Switches which must be
set in one of 32 possible code combinations.
The five Levers (numbered 1, 2, 3, 4, and 5) on the
switches are factory-set in the ON (up) position. Change
the switch settings as follows:
Slide the five Code Switch Levers in the Remote Control
to your choice of ON (up) or down positions. Use a ball-
point pen or small screwdriver and slide the Levers firmly
up or down (Figure 25).
The sixth Switch marked ON and I is for dimming control
of lights: Set Switch to ON to allow for dimming of the
lights. Set Switch to I for no dimming of the lights such as
for fluorescent bulbs.

8. Remote Control Procedures

When the switch is turned back ON the light and fan will
resume operation as they we re prior to the switch being
turned OFF.
TWO AAA
BATTERIES
BATTERY
COMPARTMENT
COVER
Figure 24
BATTERY
COMPARTMENT
COVER
Figure 25
NOTE: If your fan and light go on and off without
using your Control, you may be getting interference
from other remote units such as garage door openers,
car alarms or security systems.
To remedy this situations, simply change the
combination code in your Remote Control Transmitter.
16
REMOTE CONTROL
REMOTE CONTROL
LEVERS
ON
1 2 3 4 5 I
CODE
SWITCHES
REMOTE CONTROL
U.L. Model No.: CF145L & CF153L