Emerson HIGHPOINTE LED CF205LBQ0 Mode D'emploi page 9

3. Ceiling Fan Assembly
3.13
Place the Ceiling Cover over the Downrod. Then reinstall
the Hanger Ball (Figure 12) on the Downrod as follows.
Route the Three 80" Motor WIres through the Hanger
Ball and slide the Hanger Ball over the Downrod.
Position the Pin through the Two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and securely
tighten the Set Screw in the Hanger Ball. A loose Set
Screw could create fan wobble.
3.14
The Fan comes with Black, Blue and White Wires that
are 80" long.
Measure up approximately 6 to 9-inches above top of
Hanger Ball / Downrod Assembly (Figure 13).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
You have now completed the initial assembly of your
new Ceiling Fan. You can now proceed with hanging and
wiring your Fan.
Please call Technical Support at 1-800-654-3545
if you have any questions about installation and
operation of this Ceiling Fan.
(Continued)
PIN
DOWNROD
CEILING
COVER
Figure 12
1/2-INCH
6 TO 9
INCHES
DOWNROD
CEILING
COVER
Figure 13
9
HANGERBALL
SETSCREW
BLUE WIRE
BLACK WIRE
WHITE WIRE
HANGER BALL
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF205L-1