PRO-POINT 8619306 Manuel De L'utilisateur page 18

8619306
Problem(s)
Slow travel
speed and
weak
vibration.
Engine does
not start.
Engine runs
but rammer
does not
tamp.
Engine runs
but rammer
jumps
erratically.
18
Tamping Rammer
Possible Cause(s)
1. Slow engine speed.
2. Clutch slips.
3. Drive belt slips.
4. Over-filling of
vibrator oil.
5. Vibrator housing
defect.
1. No fuel in the tank.
2. Fuel valve is closed.
3. Throttle switch is
not open.
4. No oil in the
carburetor.
5. Spark plug is broken
or fouled.
6. Fuel filter is
plugged.
1. Clutch worn out.
2. Connecting rod or
gear is broken.
3. Too much engine oil
in the ramming
system.
1. Engine fasteners are
loose or broken.
2. Spring is broken.
3. Engine speed is too
low.
For technical questions call 1-800-665-8685
Suggested Solution(s)
1. Reset the engine RPM
appropriately.
2. Check and/or replace
clutch.
3. Check and/or replace
the drive belt.
4. Drain additional oil and
maintain at appropriate
level.
5. Check eccentric
vibrator, gear and
counterweight.
1. Fill fuel tank.
2. Open fuel valve.
3. Open throttle switch.
4. Repair or replace
carburetor.
5. Clean or replace spark
plug.
6. Clean or replace fuel
filter.
1. Repair clutch.
2. Replace rod and/or
gear.
3. Drain some oil from
1. Tighten or replace
fasteners.
2. Replace spring.
3. Increase throttle speed.
V1.0