Manually Changing Feed Plate Angle - Miller RAD-400EF Manuel Du Propriétaire

4-11. Manually Changing Feed Plate Angle

.
Motor shown
without feed
roller guard.
OM-256 907 Page 18
15
Max.
Turn knob
counterclockwise
1 Adjusting Knob
Turn adjusting knob to change torch
angle.
2 Hub Clamp Screw
Tighten screw.
3 Feed Plate Screw
Loosen screw.
.
The feed plate maximum tilt
angle is about 15 degrees from
center in both directions.
Tools Needed:
1
2
3
15
Max.
1/4 in.
Turn knob
clockwise
254 579-A / 254 716-A