Automatic Charging Mode - Why Shouldn't It Be Used; The Ability To Charge Multiple Battery Types; Soft Start Mode And Battery Repair Mode; Change Display Language - Pro-Logix SOLAR PL3730 Mode D'emploi

WARNING: Battery acid can cause serious injury and property damage!
See Safety Summary, pages 2-5.
Always wear complete eye and clothing protection and avoid touching eyes while working near battery.
Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.
Study all of the battery manufacturer's precautions, such as whether cell caps should be left in place or removed
during charging, and the recommended rates of charge for the specific battery. If you are unable to determine the
battery manufacturer's requirements for charging, always charge the battery with cell caps in place at the lowest
charging rate available.
If the battery voltage cannot be determined from the information on the battery itself, refer to the owner's manual
for the product in which the battery was installed.
Automatic Charging Mode – Why Should it Be Used?
This charger provides both Automatic and Manual Modes for charging batteries. In most cases, the Automatic
Mode is the preferred method of charging. This is because Automatic Mode will provide improved ease of
operation, more beneficial charging, optimized charging routines for the various battery types charged and a greater
level of charging control and safety than Manual Mode charging.
Many battery types, such as AGM and Gel Cell batteries, are easily damaged if specific charging parameters aren't
optimized to meet their needs. Automatic Mode charging accounts for these requirements and also delivers an
advanced multi-stage charging process that brings the battery to a more complete and beneficial final charged
state. In addition, the charging algorithm of the Automatic Mode can detect defective batteries and will stop the
charging process to prevent unsafe charging conditions.

The Ability to Charge Multiple Battery Types

Traditional battery chargers utilize basic charging controls that make them appropriate for charging only
Conventional and Maintenance Free Flooded (wet) Cell batteries. Use of traditional battery chargers on AGM, Gel
Cell or other modern batteries results in suboptimal charging and potential harm to the battery being charged.
PRO-LOGIX Wheel Charger models utilize advanced charging technology to deliver precise charge controls,
enabling them to properly charge a wide variety of battery types.

Soft Start Mode and Battery Repair Mode

PRO-LOGIX Wheel Charger models utilize a proprietary advanced Multi-Phase charging process designed to
optimally charge many types of batteries. One critical aspect of this proprietary process is the precise control
achieved through the charging process, enabling the charger to monitor a battery's specific reaction to the power
supplied. The PRO-LOGIX charging process includes a Soft Start Mode to properly charge deeply discharged
batteries and ensure that the energy from the charger is being properly incorporated into the battery. It also
includes a Battery Repair Mode to attempt to restore batteries that do not properly accept charging current. The
display will indicate BATTERY REPAIR and monitor current acceptance by the battery. Battery charging time will be
extended to allow the battery to recover. Both processes are fully automatic and require no intervention on the part
of the operator, either to initiate the process or complete it.

Change Display Language

With the unit in the OFF position, depress and hold the TOGGLE button down. Turn unit ON. This will bring you to
the language set up screen. Use the SELECT button to choose language and press START to return to the main
screen.
11