APV SW4 Mode D'emploi page 23

Nut
Thrust
ring
Ring
Housing
Fig5
3 Maintenance
Fig. 5 3.3 Assembly tool for seat seal
The assembly tool consists of:
See fig. 5
3.3.1 Installation of seat seal in the valve shaft
1.
Insert valve shaft into the body in such a manner that the seal
groove is in the valve body.
2.
Swing the two hinged brackets into the bolts (shaft is clamped).
Clamp the body via the brackets into the vice.
3.
Lightly grease seat seal. Use food-grade grease for this purpose.
Pull seal onto the ring with venting plug until the stop is reached.
4.
Insert the ring with the seat seal into the body and press it down
until it stops.
5.
Insert the thrust ring into the body. Screw on the nut and tighten
it with a hook spanner until it stops.
6.
Loosen nut. Pull ring and thrust ring out of the body.
7.
Take body out of the vice, open hinged brackets and pull the
shaft out of the body. Check correct fit of the seat seal.
See assembly tool for seat seal SW4.
DIN
NW25
NW40
NW50
NW65
NW80
NW100
ISO
Ø25
Ø38
Ø51
Ø63.5
Ø76
Ø101.6
L, T
KLL, KTL, KLT, KTT
SW 41, 42
SWE 41, 42, 43, 44
SWT 41, 42
Ref. - No
51 - 13 - 287/17
51 - 13 - 387/17
51 - 13 - 437/17
51 - 13 - 487/17
51 - 13 - 537/17
51 - 13 - 637/17
Ref. - No
51 - 13 - 287/17
51 - 13 - 387/17
51 - 13 - 437/17
51 - 13 - 506/17
51 - 13 - 562/17
51 - 13 - 637/17
LL, TL
SW 43, 44
Ref. - No
51 - 13 - 281/17
51 - 13 - 381/17
51 - 13 - 431/17
51 - 13 - 487/17
51 - 13 - 537/17
51 - 13 - 637/17
Ref. - No
51 - 13 - 306/17
51 - 13 - 406/17
51 - 13 - 456/17
51 - 13 - 506/17
51 - 13 - 562/17
51 - 13 - 637/17
25