Chauvet Professional EPIX BAR 2.0 Manuel De Référence page 5

ÉPIX™ Bar 2.0 QRG
Mounting
Mounting
Guidelines
The ÉPIX™ Bar 2.0 comes with an adjustable mounting bracket and
safety loop. The mounting bracket has three 13 mm holes used to attach a
clamp directly to the product's adjustable bracket, and serves as support
for either mounting on the floor or on the wall. The safety loop is used to
attach a safety cable.
You must supply your own clamps and make sure the clamps are capable
of supporting the weight of this product. Before mounting the product,
read and follow the safety recommendations indicated in the
Chauvet recommends using the following guidelines when mounting this
product:
·
Before deciding on a location, always make sure there is easy access
to the product for maintenance and programming.
·
Make sure that the structure or surface onto which you are mounting
the product can support the product's weight (see the
Specifications).
·
When mounting the product overhead, always use a safety cable.
Mount the product securely to a rigging point, such as an elevated
platform or a truss.
·
When rigging the product onto a truss, you should use a mounting
clamp of appropriate weight capacity.
·
The bracket adjustment knobs allow for directional adjustment when
aiming the product to the desired angle. Only loosen or tighten the
bracket knobs manually. Using tools could damage the knobs.
·
When mounting the product on the floor, make sure that the product
and cables are away from people and vehicles.
5
EN
Safety Notes.
Technical