Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ÉPIX™ Bar 2.0 QRG
AC Power
Installation
Procedure
Clear/Frost
Filter
Installation
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Before installing any product, you should completely read through the
guide that was shipped with the product.
1.
Carefully remove all items from the package and install on a secure
foundation.
2.
Connect the ÉPIX™ Bar 2.0 to the output of the ÉPIX™ Drive 642
using a standard Ethernet cable.
The ÉPIX™ Bar 2.0 includes a frost filter already installed. Follow the
procedure below to install the clear filter.
1.
Locate the end cap of the product that does not have the connecting
hardware.
2.
Remove the 4 screws from the end cap of the product.
3.
Remove filter.
4.
Re-install end cap.
Be sure to install the frost filter with the shiny side facing toward the
LEDs.
End Cap
4
EN
Publicité
Table des Matières
