Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ÉPIX™ Bar 2.0 QRG
Series
Attachment
Instructions
1
The ÉPIX™ Bar 2.0 can be attached in an end to end formation to create a
strip up to 2 meters long from just one rigging point. Do not connect any
more than 2 ÉPIX™ Bar 2.0 in a row when hanging vertically.
1.
Loosen the fastening knob and wing nut.
2.
Slide the connecting bracket out until it stops and tighten the wing
nut.
3.
Slide the second ÉPIX™ Bar 2.0 into the connecting bracket and
tighten the fastening knob, then attach the safety cable.
Wing Nut
Fastening
Knob
3
Be sure to install the safety cable last when attaching the products in
series.
2
7
EN
Publicité
Table des Matières
