Storage - John Bean EHP System IV E AT Instructions D'utilisation

R
G
T
52
F
S
6.0-5
Operation Manual - EHP System IV E AT - Tire Changer
H. Check and discharge the water every day from air
filter/ water separator 'F'. Do this by pulling down the
fitting "S" (Fig. 6.0-5).
I. The machine is equipped with an automatic lubricator.
Check the oil level weekly. When adding oil to the
lubricator, disconnect the air supply first, remove the
cup (T, Fig. 6.0-5) by twisting 1/4 turn counter
clockwise, and add oil as needed. Make sure seals
are in place when repositioning the cup.
USE ONLY OILS FOR AIR DEVICES, DO NOT USE
BRAKE FLUID OR OTHER NON RECOMMEND
LUBRICANTS.
Suggested oils for the filter/lubricator unit:
10W Non detergent / Air tool oil.
1059.tif
J. Periodically check the lubricator efficiency. One oil
drop (G, Fig. 6.5) every 4-5 operations of the bead
breaker indicates that the correct amount of oil is being
dispersed in the system.
If necessary adjust the oil flow with screw (R,
Fig.6.0-5).
K. If the machine is also equipped with a beading unit
for tubeless tires, drain condensation from the tank
daily.

6.1 Storage

In case the machine is not to be used for a long period
of time (6 months or more) it is necessary to disconnect
all power sources, discharge the bead seater tank (only
GT version), protect all parts that may be damaged,
protect the air hoses that may be damaged by the drying
process. When putting the machine back in operation,
check first the condition of all previously protected parts,
and check for correct functioning of all devices before
using the machine again.
Operator's Manual