Philips AVENT SCF862 Mode D'emploi page 21

Problem Possible cause
The appliance This appliance is
does not work. equipped with a
safety lock. This
appliance will not
work if the parts
are not assembled
correctly on the
main unit.
The steaming The appliance is
light does not connected to
not turn on. the power supply.
The jar is not
placed on
the main unit
correctly.
You have started a
second steaming
cycle immediately
after the previous
one has finished.
The water tank You have not pre-
gives off an washed the water
unpleasant tank before use.
smell during
the first few
uses.
The appliance You have not put
does not water in the water
generate tank.
steam.
There is too much
limescale buildup
in the water tank.
The steam path,
water tank steam
outlet and jar lid
steam inlet have
been blocked.
Steam is The water tank
leaking from lid is not closed
the water tank. correctly.
Solution
Assemble all parts correctly.
Before steaming, the jar lid
should be placed on the jar and
locked correctly by turning it
counterclockwise. Put the jar back
on the main unit vertically and lock
the jar by turning it clockwise.
Insert the plug in the outlet.
Place and lock the jar on the main
unit correctly.
Switch off the appliance and allow
it to cool down for 10 minutes
before you start a second steaming
cycle.
Refer to the "Cleaning and
descaling" chapter to clean the
water tank, then finish a steaming
cycle with an empty jar.
Switch off and unplug the
appliance, then add water to the
water tank.
Descale the water tank. Refer to the
"Descaling" section in the "Cleaning
and descaling" chapter.
Check the water tank steam outlet,
jar lid steam inlet and the steam
path and ensure there is nothing
blocking them.
Close the water tank lid correctly
by turning it from unlock to lock
position.
ENGLISH
23