Hendi 212028 Mode D'emploi page 7

Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning & storage.
Cleaning
• Clean the appliance after each use.
• Never immerse the appliance in water or other
liquids.
• Clean the outer surface with a slightly damp cloth
or sponge with some mild soap solution.
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are still
unable to solve the problem, please contact the supplier/service provider.
Problems
Connected to the power supply
but the power switch (2) does not
light up when it is turned on.
The appliance does not heat up
but power switch (2) light up.
Technical specification
Item no. : 212028
Operating voltage and frequency :
220-240V~ 50/60Hz
Rated input power : 3000W
Temperature setting : 50°C ~ 300°C (MAX)
Remark: Technical specification is subjected to change without prior notification.
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Store the appliance in a cool, clean and dry place.
• Never put objects on the baking surface as it may
crack.
Possible cause
Power plug is not connected
properly to the electrical power
supply.
Power switch (2) defective.
Hi-limiter (Thermal cut-out) ac-
tivates
Temperature control (1) defective
Heating element defective
Protection class : class I
Waterproof protection class : IPX3
Dimension : 450x470x(H)160mm
Net weight : approx. 22 kg
Possible solution
Check again to make sure it is
connected properly.
Contact your supplier.
RESET the Hi-limiter (thermal
cut-out). See RESET on page 6.
Contact your supplier.
EN
7