Hendi 212028 Mode D'emploi page 6

Operation
• Clean the baking surface with a clean damp cloth
before each use & let dry afterwards.
• Connect the power plug with a suitable electri-
cal outlet. Turn on the switch(2),it will light up in
green to show that it is connected to the electri-
cal power supply.
• Start the appliance by turning the temperature
control (1) in a clockwise direction to select the
required baking temperature.
• Wait for about 15 ~ 20 minutes to let the baking
plate heating up to about 250-300°C (Max).
• Then, pour a small amount of crepe batter onto
the baking plate with a spoon. Use a wooden
spreader (4) to spread it in circular movements.
Note: Moisten the wood spreader before use. This
prevents the batter from sticking to the spreader
(4).
• Allow the crepe to cook on one side until its
surface is no longer liquid visibly. Use a wood-
en spatula or heat-resistant plastic spatula (not
supplied) to lift one side of the crepe gently. The
crepe should be visibly cooked, may be some
in brown. In this case, the crepe is ready to be
EN
flipped.
RESET the Hi-limiter (thermal cut-out)
Please note that a RESET button is located at the
rear side of the appliance covered with a protective
cap. (See diagram)
• Unplug the appliance from the electrical outlet
first.
• Allow the appliance to completely cool down.
• Unscrew the black protective cap of the RESET
button.
• Press the RESET button of the Hi-limiter (ther-
mal cut-out). You should hear a click sound.
• Screw back the protective cap on the RESET but-
ton.
6
Note: When you pour the batter onto the hot bak-
ing plate, you might hear some slight cracking
noise caused by difference in temperature. This
is normal.
Note: Do not overcook the crepe, or the texture
will become rubbery. The crepe can be cooked
quickly under high temperature. So, it can be
flipped within about 2~3 minutes if you select a
suitable temperature.
• Turn the crepe over to other side carefully. It only
needs to cook on the other side for about 30 ~ 40
seconds.
• Carefully remove the crepe from the baking plate.
Continue making more crepes until you ran out
of batter. Do not use hand to touch the crepe as
it is still hot.
• If necessary, adjust the temperature by rotating
the temperature control.
• Switch OFF the appliance by rotating the temper-
ature control (1) anti-clockwise direction to 0°C
and turn the switch(2) off.
Attention! Disconnect the power plug when not in
use. Leave the appliance to cool down completely
before cleaning and storing.