Operation; Maintenance - Wolf Garten VA 303 E Notice D'instruction D'origine

Operation

Operating times
 Please check noise abatement regulations prevailing in your
country.
Feed cable through the strain relief
 Please feed cable through the strain relief.
Connecting to the mains (230 Volts, A.C., 50 Hz)
 The machine operates from any normal household mains sup-
ply.
3
Note: Residual current protection device
These protection devices safeguard while touching
damaged wires, from insulation flaws and in certain cases,
also while damaging live wires.
 We recommend that the equipment only be plugged into
a power socket, which is protected by a residual current
protection device (RCD) with a residual current of not
more than 30 mA.
Adjust operating depth
1
Caution! Only with motor switched off and non-mowing
scarifying / aerating roller.
1
Caution! The working depth must be set correctly befo-
re the unit is used for the first time. The hight adjust-
ment lever may be moved to the first working depth
setting only (position „1")
3
Note
If the blades/aerator tines are worn, the working depth must
be readjusted subsequently. An optimum working depth is
obtained when the blades/aerator tines of the cutter are in-
serted 2–3 mm into the ground.
If the working depth is too great, the unit may be overloaded
and cause damage. Therefore, ensure that the working
depth is set correctly.
 Increasing the working depth (cutters towards the
ground) (a, b)
–
Set height adjustment lever (depending on model) accor-
ding to wear.

Maintenance

General
1
Attention! Rotary cutter blade
Before all maintenance and cleaning work:
 pull out the power plug.
 Do not touch running blades.
Cleaning
 Clean the unit thoroughly with a brush after each use.
 Do not spray with water.
12
E
J
–
Settings pos. „2, 3, 4" are not required until the blades/aera-
tor tines are worn. Depending on the degree of wear, gradu-
ally set the blades lower, starting at pos. „2".
 Reducing the working depth (a, c)
3
Scarifying / aerating test:
 Set height adjustment lever in working position „1, 2, 3,
.
J
4"
 Start tool
G
 On hearing stones being hit or blocking of the motor im-
mediately switch off tool
 Reducing the working depth
ment lever in working position „1, 2, 3, 4".
 Start scarifying / aerating test again
 When used regularly the working depth may be adjusted ac-
cording to the wear of the blade (+).
Recommended working heights
 well kept lawns with stone-free, soft ground
–
Set tool exactly to ground height
 stony, untidy lawns
–
Set tool to ground height
–
Increase working height if stones are thrown up
 unkempt, extremely mossy lawns
–
Start with a high working height
–
Do not overload appliance (reduce working height if motor
blocks)
–
Cut vertically and crossways several times
Scarifying / aerating
1. Depress button (1) and hold.
2. Lift up bar (2) and release button (1).
3. Switch-off motor: Release bar (2).
1
Important:
Place the cable firmly off the lawn or on the already cut side
of the lawn when starting to mow.
 Store unit in a dry room.
3
We recommend
Allow a WOLF-Garten-service centre to check the unit in the
autumn.
J
: Set height adjust-
G
G