Operation - Wolf Garten 2.48 HA Mode D'emploi

Operation

Operating times
Please check noise abatement regulations prevailing in your
country.
Starter cord assembly
1. Lift and hold operator presence bail arm
2. Pull the starter rope slowly to the holding bracket.
Twist the cord through the holder
3.
3
Always remove the starter cord from the holder before
folding the mower handles.
Oil Fill
J
1
Check oil level with mower standing on level ground.
Fill crankcase with quality oil SAE 30 up to the mark „Full"
on dipstick. (Do not overfill.) Capacity approx. 0,6 litre.
Screw in dipstick according to illus.
Filling with Petrol
K
1
Do not smoke - no naked flames! off engine. Avoid spil-
ling petrol when engine is warm.
Use „low-octane petrol" (do not use Super Plus).
Avoid petrol spillage.
Do not inhale vapour.
Hanging the grass bag
1
Only when mower is stationary and rotating blade has
come to complete standstill.
1. Lift the protective flap.
2. Hang the grass bag in the chassis with the hooks in the reces-
ses (see arrow).
3. Replace the protective flap.
Use of height adjustment
1
Only when mower is stationary and rotating blade has
come to complete standstill.
1. Pull handle forward.
2. Allow to lock into position at desired height.
Selection of cutting heigth
If possible, mow when grass is dry in order to protect turf. Do
not set cutting position too low when mowing very tall or wet
grass.
We recommend an average cutting height of 4,o cm - 5,0 cm.
14
G (1).
.
H
L
M
Start
On a flat surface, if possible not in high grass.
Cold start
N
1. Open gas cock .
2. Set hand throttle G (1) on start.
3. Raise and hold the safety bracket
4. Pull starter grip H and return it slowly by hand.
5. After starting, slowly move the hand throttle to "Operate".
Wheel drive
1. Wheel drive on: Raise drive bracket
2. Wheel drive off: Relapse drive bracket
Warm start
G
Set hand throttle (2) on operate.
3
If the motor does not start after the second attempt,
then place the hand throttle on start and start again.
Stop Motor
Release safety bracket
Tips for mowing
O
To prevent strips of grass from being left unmowed, the cutting
paths must always overlap a few centimeters.
Always turn the mower on a surface that has already been
mowed.
Emptying the grass bag
1
Only when mower is stationary and rotating blade has
come to complete standstill.
The grassbox is full and should be emptied as soon as
grass clippings remain uncollected on the ground behind
your mower.
Fixing of handle
Take care that the switch cable does not be-come caught and
crushed when folding the handlebar.
G (3).
G
(3).
G (3).
(2).
G
G