Operation; Operating Times - Wolf Garten POWER 34-37-40 Mode D'emploi

EN
Power pack insertion (Fig. O P )
Open the cover of the power pack compartment
Î
O 1 .
Insert the power pack into the compartment O 2
Î
making sure it engages at position 2 O 4 .
Insert the safety key into its socket P 1 , then turn
Î
it anti-clockwise until it reaches position "1" P 2 .
Close the cover P 3 .
Î
Power pack removal (Fig. O P )
Risk of injuries due to the rotating mower
blade.
¾ Only adjust the lawnmower with the
motor switched off and the mower blade
at a standstill.
Switch the motor off.
Î
SAFETY ROUTINE
¾ Open the cover O 1 .
¾ Turn the safety key clockwise until it reaches
position "0" P 2 , then remove it.
¾ Use the power pack release device O 5 .
¾ Remove the power pack O 2 .
¾ Close the cover P 3 .

Operation

Operating elements (Fig. Z )
1 Handle
2 Operator presence control
3 Fill level indicator
4 Grass collector
5 Delector lap
6 Handle height adjuster
7 Cutting height adjuster
8 Cutting height indicator
9 On/off switch (switch-on preventer)
10 Operator presence control
11 LED indicator
12 Power pack release
13 Cover
14 Changeover switch (cut-collect/mulch)
15 Mower blade
26
DANGER !
LED state indicator (Fig. Z /11)
LED status Meaning
Steady green Power pack charge 40% - 100%
Steady yellow Power pack charge 5% - 40%
Power pack charge 0% - 5%
Steady red
Motor sluggish or blocked
Power pack temperature too high
Slow lashing red
or too low
Lawnmower temperature too high
Quick lashing
Overcurrent release (or release due
red to low or high voltage)

Operating times

Observe the times stipulated in local byelaws.
Î
Check if there are any operating time limitations
Î
with your local authorities.
Attaching the grass collector (Fig. L )
Risk of injuries due to the rotating mower
blade.
¾ Only adjust the lawnmower with the
motor switched off and the mower blade
at a standstill.
Switch the motor off.
Î
SAFETY ROUTINE
¾ Open the cover O 1 .
¾ Turn the safety key clockwise until it reaches
position "0" P 2 .
¾ Use the power pack release device O 5 .
¾ Put the power pack into position 1 O 3 for
storage and transport.
¾ Close the cover P 3 .
Raise the delector lap L 1 .
Î
Î Hold the grass collector by its handle and tilt it
slightly, so that the grass collector can be attached
by its hooks in the recesses on the rear side of the
lawnmower L 2 .
Î Hook the grass collector on to the lawnmower
L 2 .
Fold the delector lap downwards again L 3 .
Î
DANGER !
72V Li-ION POWER 34-37-40
Operation