Cruising In Other Conditions; Cruising In Salt Water Or Other Conditions - Yamaha VF150 Manuel De L'utilisateur

Operation
1. Cooling water inlet
EMU40712
Procedure for shallow water cruising
1. Move the remote control lever to the
neutral position.
2. Push the " " (up) side of the power trim
and tilt switch to tilt the outboard motor
up slightly to the desired position.
WARNING! Using the power trim and
tilt switch on the bottom cowling while
the boat is moving or engine is on
could increase the risk of falling over-
68
1
ZMU08012
N
ZMU07034
N
ZMU06926
board and could distract the operator,
increasing the risk of collision with an-
other boat or an obstacle.
1
UP
1. Power trim and tilt switch
3. To return the outboard motor to the nor-
mal running position, push the "
(down) side of the power trim and tilt
switch to tilt the outboard motor down
slowly.
DN
1
1. Power trim and tilt switch
EMU28196

Cruising in other conditions

Cruising in salt water
After operating in salt water, flush the cooling
water passages with fresh water to prevent
them from becoming clogged. Also rinse the
outside of the outboard motor with fresh wa-
ter.
Cruising in muddy, turbid, or acidic water
Yamaha strongly recommends that you use
the optional chromium-plated water pump kit
(see page 20) if you use the outboard motor
[EWM01851]
ZMU06986
"
ZMU06987