Safety Information; Outboard Motor Safety; Propeller; Rotating Parts - Yamaha VF150 Manuel De L'utilisateur

EMU33623

Outboard motor safety

Observe these precautions at all times.
EMU36502

Propeller

People can be injured or killed if they come in
contact with the propeller. The propeller can
keep moving even when the motor is in neu-
tral, and sharp edges of the propeller can cut
even when stationary.
 Stop the engine when a person is in the
water near you.
 Keep people out of reach of the propeller,
even when the engine is off.
EMU40272

Rotating parts

Hands, feet, hair, jewelry, clothing, personal
flotation device (PFD) straps, etc., can be-
come entangled with internal rotating parts of
the engine, resulting in serious injury or
death.
Keep the top cowling in place whenever pos-
sible. Do not remove or replace the top cowl-
ing with the engine running.
Only operate the engine with the top cowling
removed according to the specific instruc-
tions in the manual. Keep hands, feet, hair,
jewelry, clothing, PFD straps, etc., away from
any exposed moving parts.
EMU33641

Hot parts

During and after operation, engine parts are
hot enough to cause burns. Avoid touching
any parts under the top cowling until the en-
gine has cooled.
EMU33651

Electric shock

Do not touch any electrical parts while start-
ing or operating the engine. They can cause
shock or electrocution.

Safety information

EMU46150

Power trim and tilt

Body parts can be crushed between the out-
board motor and the clamp bracket when the
outboard motor is trimmed or tilted. Keep
body parts out of this area at all times. Make
sure that no one is in this area before operat-
ing the power trim and tilt mechanism.
The power trim and tilt switches operate even
when the main switch is turned to the "
(off) position. Keep people away from the
power trim and tilt switches whenever work-
ing around the outboard motor.
Never get under the outboard motor while it
is tilted, even when the tilt support shaft is in-
stalled or the tilt support lever is locked. Se-
vere injury could occur if the outboard motor
accidentally falls.
EMU33672

Engine shut-off cord (lanyard)

Attach the engine shut-off cord so that the
engine stops if the operator falls overboard or
leaves the helm. This prevents the boat from
running away under power and leaving peo-
ple stranded, or running over people or ob-
jects.
Always attach the engine shut-off cord to a
secure place on your clothing or your arm or
leg while operating. Do not remove it to leave
the helm while the boat is moving. Do not at-
tach the cord to clothing that could tear
loose, or route the cord where it could be-
come entangled, preventing it from function-
ing.
Do not route the cord where it is likely to be
accidentally pulled out. If the cord is pulled
during operation, the engine will shut off and
you will lose most steering control. The boat
could slow rapidly, throwing people and ob-
jects forward.
"
1