Step 1: Assembling The Frame - Power Maxx SP14111 Mode D'emploi

Step 1: Assembling the Frame

1. Assemble all frame parts one after the other. Start with the frame part with the three
holes (2). The support bar will subsequently be fi tted to this part.
2. Secure the frame parts with the short screws (1), the self-locking nuts (14), one
curved washer (12) and one flat washer (13). Make sure that the curved washers
(12) are on the top side of the frame and that the fl at washers (13) are fi tted on the
underside of the frame. CAUTION: Only fully tighten the screws once the complete
frame has been locked together!
Tighten
Hold
08114_de-gb-fr-nl_V2.indb 29 08114_de-gb-fr-nl_V2.indb 29
3. Tighten the screws: Hold the nut
with the spanner and tighten the
screw with the hex key. It is essen-
tial that you use the tool supplied to
tighten the screws. Self-locking nuts
cannot be tightened by hand.
29
17.11.2014 08:37:17 17.11.2014 08:37:17