Connection To A Computer Or Printer - Promax PROPOWER - 5 Mode D'emploi

USER'S MANUAL. PROPOWER-5
The measurements carried out on CH-FR operating mode are more actual since they
are taken using an integration procedure and they consider the whole channel
spectrum.
To leave the configuration menu of the DATALOGGER mode, just press the key of
the operating mode you wish to access.

4.3 Connection to a Computer or Printer.

The PROPOWER-5 permits the connection to a PC or to a serial printer for data
transfer, by means of the connection cable model CC-208.
Do not connect any cable other than that supplied by the manufacturer,
otherwise serious damage may be caused to the equipment.
1) Prior to connecting the equipment to a PC, disconnect both from their
respective power supplies.
2) Connect the end of the connection cable corresponding to the PROPOWER-5
to connection [8] and the other end to the serial port of your computer or
printer.
Once the computer or printer have been connected, select on the PROPOWER-5
the LOGGER operation mode. If PRINT function is selected data will be dumped to the
remote unit through the serial port.
The communication parameters used by the PROPOWER-5, and which therefore
must be defined on the remote unit (PC or printer) are the following:
Rate
Data bits
Parity
Stop bits
The remote control software RM-010 (optional accessory) permits to carry out
from a computer the following options:
1) CHANNELS PLAN PROCESSOR: Modify, add or delete channel plans.
2) CONFIGURATION: Permits to modify all the configuration parameters.
3) DATALOGGER: Permits to edit and to save all the measurement contained in a
logger.
4) UPDATE: Allows to update the PROPOWER-5 software version.
07/2006
19200 bauds
8 bits
None
1
REMARK
IMPORTANT
Page 29