Connection To A Computer Or Printer; Datalogger - Promax 8 SE Mode D'emploi

4.3

Connection to a Computer or Printer.

PROMAX-8
The
data transfer, by means of the connection cable model CC-208.
Do not connect any cable recomenated that supplied by the manufacturer,
otherwise serious damage may be caused to the equipment.
1) Prior to connecting the equipment to a PC, disconnect both from their
respective power supplies.
2) Connect the end of the connection cable corresponding to the
PROMAX-8
your computer or printer.
Once the computer or printer have been connected, select on the
PROMAX-8
SE the LOGGER operation mode. If PRINT function is selected data will
be dumped to the remote unit through the serial port.
The communication parameters used by the
therefore must be defined on the remote unit (PC or printer) are the following:
Rate
Data bits
Parity
Stop bits
The remote control software RM-010 (optional accessory) permits to carry out
from a computer the following options:
1) CHANNELS PLAN PROCESSOR: Modify, add or delete channel plans.
2) CONFIGURATION: Permits to modify all the configuration parameters.
3) DATALOGGER: Permits to edit and to save all the measurement contained in a
logger.
4) UPDATE: Allows to update the
Page 40
SE permits the connection to a PC or to a serial printer for
SE to connection [8] and the other end to the serial port of
PROMAX-8
USER'S MANUAL.
PROMAX-8
SE, and which
19200 bauds
8 bits
None
1
SE software version.
PROMAX-8
SE
07/2011