Promax PROPOWER - 5 Mode D'emploi page 63

USER'S MANUAL. PROPOWER-5
The first page of the global configuration menu permits to modify the following
parameters:
a) CHANNEL PLAN
It allows you to choose the active channel plan between the 10 channel plans that
unit can store (IBER, etc.).
b) EDIT CHANNEL PLAN.
When selecting this field and pressing the rotary selector, the unit accedes to the
active CHANNEL PLAN.
The attached figure shows an example of
channel plan. The first line shows the name of the
channel plan (IBER in the figure), the units of
measurement (dBm). Next line shows the head of the
columns that constitute the channel plan: the first
column (CHAN) shows the name of each channel
(UL12, DL13,...) and the second one (FREQ) the
associated frequency, in MHz. The third column
(BW) defines channel bandwidth, in MHz. The fourth column (ON) activates or
deactivates the channel.
The maximum number of channels in a channel plan is of 140.
The activation (ON) / deactivation (OFF) of the channels affects to the following
operation modes: CH-FR, SCAN and DATALOGGER. When a channel has been
deactivated, this one will not be able to be tuned nor to be measured. This property
allows to make agile the operation of the PROPOWER-5, because it allows to activate
only those channels in which we are interested.
The Edit Channel Plan function allows to automatically activate all the channels
defined in the channel plan by means of the ALL field on the third line. When to the
right of ALL we select ON, all the channels of the plan will be activated, otherwise, if we
select OFF all channels will be deactivated. In order to activate / deactivate a particular
channel, turn the rotary selector [9] until this one appears shaded and then press it, the
cursor will jump to the ON column, then turning the selector it will be possible to activate
it (it appears a cross) or to deactivate it (it does not appear a cross).
Below it appears ∆FCH set to 0,00 MHz. In a range from -2,00 MHz to +2,00
MHz. i.e. the displacement of the channel tuning frequency for those channels that
present a central frequency displaced respect to the one of the corresponding standard
system.
Also this parameter (∆FCH) can be edit in the channel configuration by means of
CONFIG CH-FR option.
In order to quit the Channel Edit press the key associated to the operation mode
which you wish to accede.
To modify the rest of characteristics of the channel plans it is necessary to have
the RM-010 software (optional accessory).
07/2006
Figure 6.- Editing a channel plan.
Page 15