Global Configuration Menu - Promax PROPOWER - 5 Mode D'emploi

To access any operating mode, simply press the corresponding key.
The parameters relative to a particular operating mode can be modified through
the configuration menu associated to the mode. In order to accede to the
configuration menu associated to a particular operating mode, simply press the
CONFIG key [14]. Some modes have more than one configuration page, to accede to
the second page it is necessary to press the CONFIG key again. The general
parameters of configuration (selecting/editing the channel plan, measurement units,
language, etc.) can be changed through the Global Configuration Menu, to which it is
acceded by pressing again the CONFIG key [14]. To leave a configuration menu, just
press the key of the operating mode you wish to accede.
MEASUREMENTS
Figure 4.- PROPOWER-5 configuration menus.

4.2.1 Global configuration menu

In order to accede to the global
configuration menu, from any operating
mode (SCAN, CH-FR, SPECT, etc.), you
must press the CONFIG [14] key repeatedly (the first
time that presses this key accedes to the configuration
menu relative to the mode in use, which can have
more than one page). The global configuration menu
consists of two pages (attached figure shows the
first one), to switch from one to the other simply press the CONFIG [14] key.
In order to modify the state of a given parameter, you must turn the rotary selector
[9] until this one appears shaded and next press it, then the value of the parameter will
appear shaded and turning the selector a new value will be able to be defined. Finally,
to validate the new state, press the rotary selector [9] again.
Page 14
MEASUREMENTS
CONFIGURATION
(*) Parameters that affect all measurements
USER'S MANUAL. PROPOWER-5
GLOGAL
CONFIGURATION (*)
Figure 5.- Global configuration. 1/2.
07/2006