Work Instructions - Flex LBE 125 18.0-EC Notice D'instruction D'origine

LBE 125 18.0-EC/LB 125 18.0-EC/L 125 18.0-EC
To switch off the power tool, release

the switch rocker by pressing the rear
end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Preselecting the speed
(for LBE 125 18.0-EC)
To set the operating speed, press the

speed control button. Selected speed is
maintained even when switching off.
Gently press the switch to accelerate the

power tool up to the preselected speed.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
Overload protection: switches the
–
machine off in the event of overload.
Sensor-controlled temperature
–
monitoring: If there is a risk of
overheating the machine switches off.
Adjusting the guard
To adjust the tool to the task at hand, the
guard hood can be adjusted by 12 notches
on 360° without a tool.
CAUTION!
Risk of injury! Wear protective gloves.
Remove the battery.

Turn guard hood opposite to the

direction-of-rotation arrow on the gear
head to the required position.

Work instructions

NOTE
When the power tool is switched off,
the grinding tool continues running briefly.
Rough-grinding
WARNING!
Never use cutting-off wheels for rough-
grinding.
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
WARNING!
A special cutting guard must be used for
cutting.
See manufacturer's accessories catalogue.
– The angle grinder must always be
operated backwards.
25