Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8836363
2.
Install an in-line shutoff valve or regulator to allow
immediate control over the air supply in an emergency,
even if a hose is ruptured.
3.
Discontinue tool use if it does not work properly or air is
leaking. Tag or mark the tool as 'defective' or 'out of
service' until repaired.
4. Check the manufacturer's maximum pressure rating for air
tools and accessories. Compressor outlet pressure must be
regulated to never exceed the maximum pressure rating of
the tool (see Specifications). Exceeding the maximum PSI
rating can create a bursting hazard, causing injury and
property damage.
5.
Never use oxygen, combustible gas or any other bottled
gas as a power source. Any power source other than an
air compressor could cause an explosion and serious
personal injury.
6.
Turn OFF the valve and discharge any remaining air
pressure after each use or before adjusting the tool.
7.
Do not leave the air tool unattended with its compressed
air supply on. Turn off the compressed air supply and bleed
the air tool of any remaining compressed air before leaving
the air tool unattended.
8.
Serious injury may occur from loose debris being propelled
at high speeds from the compressed air stream. Always
wear OSHA approved safety glasses to protect the eyes
during operation of the air compressor.
9.
Always turn off the air compressor and drain tank pressure
completely before attempting maintenance or attaching air
tools. Release pressure slowly from the system.
AIR HOSE PRECAUTIONS
1.
Inspect the tool's air hose for cracks, fraying or other faults
before each use. Discontinue use if the air hose is damaged
or hissing is heard from the air hose or couplers. Replace
the defective air hose.
6
40-TON HYDRAULIC SHOP PRESS
For technical questions call 1-800-665-8685
V1.0
Publicité
Table des Matières
