Lubrication - PRO-POINT 8836363 Manuel D'utilisateur

8836363
4. Pump the handle for several full strokes to eliminate any air in
the system.
4.1 An alternative is to connect the quick coupler (#P45)
to an air source and switch on the air valve (#P44).
Allow the pump to cycle several times to eliminate any
air. Shut the air valve off.
5. Check the oil filler hole and if necessary, top off with more
hydraulic oil.
6. Restore the oil filler nut. Close the release valve by turning
clockwise.
7. Test the ram several times for proper operation before
putting it into use. Do not use the ram if it still does not
appear to be working properly. Have a qualified service
technician service or repair the hydraulic system.
CLEANING
Clean the outside of the press with a dry, clean and soft cloth
and periodically lubricate the joints and all moving parts with a
light oil as needed.

LUBRICATION

Inspect and lubricate the tool when required. Only use light oil
to lubricate the tool. Other lubricants may not be suitable and
could damage the tool or cause a malfunction during use.
NOTICE! NEVER use a penetrating oil to lubricate the tool.
Penetrating oil may act as a solvent that will break down the
grease and cause the tool to seize up.
1. All air tools have an internal coating of grease to prevent
corrosion during shipping and storage. Remove this grease by
adding a generous amount of air tool oil in the air inlet and
then run the tool under no load until the exhaust is clear.
2. Manually add a drop or two of air tool oil into the tool's
coupler plug before each use and after every hour of
continuous use. The tool will not work properly without
lubrication and parts will wear prematurely.
14
40-TON HYDRAULIC SHOP PRESS
For technical questions call 1-800-665-8685
V1.0