PRO-POINT 8836363 Manuel D'utilisateur page 16

8836363
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does
not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
PROBLEM(S)
Tool runs at
normal speed,
but loses
power under
load.
Tool runs
slowly. Air
flows slightly
from exhaust.
Tool runs
slowly. Air
flows slightly
from exhaust.
Press
efficiency
drops.
16
40-TON HYDRAULIC SHOP PRESS
POSSIBLE CAUSE(S)
Motor parts worn.
Motor parts jammed
with dirt particles.
OR
Airflow blocked by
dirt.
1. Air regulator in
closed position.
2. Damage or
excessive wearing
of internal parts.
Low hydraulic oil.
For technical questions call 1-800-665-8685
SUGGESTED SOLUTION(S)
1. Have a qualified
technician service the
tool.
2. Replace tool or parts.
1. Check air inlet filter for
blockage.
2. Pour air tool lubricating
oil into air inlet as per
lubrication instructions for
clearing shipping grease.
3. Operate tool in short
bursts to clear debris.
4. If tool still jammed, clean
tool and lubricate per
lubrication instructions.
1. Open the air regulator to
desired airflow.
2a. Have a qualified
technician service the
tool.
2b. Replace tool or parts.
Purge air from hydraulic
system as described under
Operation—Before First Use.
V1.0