PRO-POINT 8836363 Manuel D'utilisateur page 15

V1.0
3. Avoid adding too much air tool oil as this can cause premature
power loss and eventual tool failure. A qualified technician will
need to take the tool apart and clean out the excess oil.
4. Apply a generous amount of air tool oil to the tool before
storing it for an extended period of time (overnight,
weekend, etc.). Run the tool for approximately 30 seconds
to ensure the oil is evenly distributed throughout the tool.
Store it in a clean and dry location.
STORAGE
When not in use for an extended period, apply a thin coat of
lubricant to the steel parts to avoid rust. Remove the lubricant
before using the tool again.
Store the press in a dry location with the ram and piston fully
retracted.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or
by-laws for electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing
uncontrolled discharge of waste oil.
DISPOSAL - HYDRAULIC FLUID
Do not drain hydraulic oil into the sewer system or dispose in
an uncontrolled location. Hydraulic fluid may take more than a
year to breakdown in the environment and the ingredients may
still be toxic. Contact your local municipality for proper
disposal instructions or locations.
Visit www.princessauto.com for more information
40-TON HYDRAULIC SHOP PRESS 8836363
15