Waste Management - GYS FLASH 50.24 HF Mode D'emploi

GYSFLASH 50.24 HF EN
Connection / disconnection :
• Disconnect the power supply before plugging or unplugging the
connections to/from the battery.
• Always ensure the Red clamp is connected to the «+» battery
terminal first. If it is necessary to connect the black clamp to the
vehicle chassis, make sure it is a safe distance from the battery and
the fuel/exhaust pipe. The charger must be connected to the mains.
• After charging, disconnect the charger from the mains, then
disconnect the clamp from the car body and then disconnect the
clamp from the battery, in the indicated order.
Connection:
• The charger must be connected to an EARTHED power supply.
• The connection to the power supply must be carried out in
compliance with national standards.
Maintenance:
• If the power supply cable is damaged, it must be replaced by a
cable or a special set, available from the manufacturer or its after
sales team.
• Maintenance should only be carried out by a qualified person.
• Warning ! Always disconnect from the mains before performing
maintenance on the device.
• The device does not require any specific maintenance.
• If the internal fuse is melted, it must be replaced by the manufacturer,
its after sales service or an equally qualified person to prevent
danger.
• Do not use solvents or any agressive cleaning products.
Regulations:
• Machine compliant with European directives.
• The certificate of compliance is available on our website.
• EAEC Conformity marking (Eurasian Economic Community).

Waste management:

• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a domestic bin.
13