Programming - Set Up; How To Set The Functions - Lowara GEN Série Directives D'installation Et D'utilisation

2. PROGRAMMING - SET UP

PROGRAMMING CAN BE PERFORMED ONLY WITH THE ENGINE OFF AND THE
"KEY-OPERATED SELECTOR SWITCH IN THE MAN POSITION!"
Read the operating instructions carefully before you start programming, so as to avoid
entering incorrect settings that could cause malfunctions.
Any modification operations may be performed by qualified technicians only!
Set the selector switch to the "MAN" position.
Power the electric panel, then press and hold down the PROG / RESET / ENTER pushbutton
for longer than 5 seconds, the cursor will start blinking.

HOW TO SET THE FUNCTIONS

Use the UP and DOWN keys to select the desired parameter
Use the ENTER key to access the programming mode (the cursor will start blinking)
Use the UP and DOWN keys to modify the value
Press the PROG/RESET/ENTER key to confirm the value
Proceed as described above for each function you wish to set
It is possible to exit the access or the SET-UP program at any time by turning the key-
operated selector switch to the "0" or "AUTO" position!
1 parameter
2 value
Use the UP key to increase the value
Use the DOWN key to decrease the value
Use the enter key to confirm
Password value : 006
31