Parameters 2Nd; General Remarks; Parameter 2Nd - GT Trans Pocket 4000 CEL Mode D'emploi

Parameters 2nd

General remarks

Parameter 2nd

The function Eln (electrode-line selection) can be set separately for the processes "Rod
electrode welding", "Rod electrode welding with CEL electrode" and "Special processes".
The settings remain stored in the memory until the next time any change is made to the
setting in question.
The function Eln (electrode-line selection) and the available settings are described in the
section headed "Rod electrode welding".
Eln
Electrode-line - electrode-line selection - con / 0.1 - 20 / P
Factory setting
The function r (welding circuit resistance) is described in the section headed "Measuring
the welding circuit resistance".
CSS
Comfort Stop Sensitivity - response sensitivity of the TIG-Comfort-Stop function: 0.5 -
5.0 / OFF
factory setting
Depending on the set value for the CSS parameter the following is required for triggering
the TIG-Comfort-Stop option:
0,5 - 2,0
2,0 - 3,5
3,5 - 5,0
r
r (resistance) - Welding circuit resistance - x milliohms (e.g. 11.4 milliohms)
The function L (welding circuit inductivity) is described in the section headed "Indicating
welding circuit inductivity L".
L
L (inductivity) - Welding circuit inductivity - x mikrohenrys (e.g. 5 mikrohenrys)
The function Ast (anti-stick) is described in the section headed "Rod electrode welding".
ASt
Anti-Stick - ON / OFF
factory setting
NOTE! For the "TIG welding" process, only the parameters r (welding circuit
resistance) and L (welding circuit inductivity) are available.
for "Rod electrode welding" process: con
for "Rod electrode welding with CEL electrode" process: P
for "Special processes": con
OFF
NOTE! We recommend a set value of 2.0. However, if the welding process is
frequently stopped unintentionally, increase the value for the CSS parameter.
low increase of the arc
mean increase of the arc
high increase of the arc
ON
28