Starting To Use The Power Source; General Remarks; Utilisation For Intended Purpose Only; Machine Set-Up Regulations - GT Trans Pocket 4000 CEL Mode D'emploi

Starting to use the power source

General remarks

Utilisation for The power source is intended to be used SOLELY for rod electrode welding, TIG welding
intended purpose as well as gouging.
only Any other use, or any use going beyond the above, is deemed to be "not for the intended
purpose" and the manufacturer shall not be liable for any damage resulting therefrom.
"Utilisation for the intended purpose" shall also be deemed to encompass:
-
-
Machine set-up The power source is tested to "Degree of protection IP23", meaning:
regulations -
-
The power source can be set up and operated outdoors in accordance with IP23. Howe-
ver, the built-in electrical components must be protected against direct wetting.

Mains connection

The venting duct is a very important safety feature. When choosing the machine locati-
on, make sure that it is possible for the cooling air to enter and exit unhindered through
the louvers on the front and back of the machine. Any electroconductive metallic dust
from e.g. grinding-work must not be allowed to get sucked into the machine.
The power source is designed to run on the mains voltage given on the rating plate. The
mains cable and plug are ready-mounted. For details of fuse protection of the mains
supply lead, please see the Technical Data.
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described here until you have read and
completely understood all of the following documents:
- these Operating Instructions
- all operating instructions for the system components, especially the "Safety
rules"
the observance of all instructions in the operating manual
the carrying out of all prescribed inspection and maintenance work
Protection against penetration by solid foreign bodies with diameters larger than
12.5 mm (.49 in.)
Protection against spraywater up to an angle of 60° to the upright
WARNING! A machine that topples over or falls from its stand can easily kill
someone. Place equipment on an even, firm floor in such a way that it stands
firmly.
NOTE! Inadequately dimensioned electrical installations can lead to serious
damage. The mains lead, and its fuse protection, must be dimensioned in
accordance with the local power supply. The technical data shown on the rating
plate shall apply.
14