Tr 3000 Remote-Control Unit - GT Trans Pocket 4000 CEL Mode D'emploi

TR 3000 remote-
control unit
Fig.5
Fig.6
(30) Welding-current range selector switch for selecting the welding-current range
-
-
Fig.7
(27)(26) (28)
TR 3000 remote-control unit - front view
(29) (30)
TR 3000 remote-control unit - view from the
left side
within which the welding current can be set using the welding-current setting dial(28)
min - 150 A:
0 ls owest possible welding current
10 welding current is 150 A
100 A - max:
0 welding current is 100 A
10 highest possible welding current
(32)
TR 3000 remote-control unit - view from the
right side
(26) Welding current indicator ... for
selecting the welding amperage.
Before the start of welding, the machi-
ne automatically displays a guideline
value based on the programmed
parameters. During welding, the
actual value is displayed.
(27) HOLD indicator ... every time you
finish a welding operation, the actual
values for welding current and voltage
are stored, and the "Hold" indicator
lights up.
(28) Welding-current setting dial ... for
selecting the welding current .
(29) Process selector switch ... for
selecting the welding process
- Rod electrode welding
- Rod electrode welding with CEL-
electrode
- Special processes
- TIG welding with touch-down
ignition
(31) Arc-force setting dial
Manal-electrode welding ... for influen-
cing the short-circuiting amperage at
the instant of droplet transfer
0
100 harder, more stable arc
(32) Change-over switch for polarity
reverser ... for actuating the polarity
reverser (optional)
+ Positive welding potential at the (+)
current socket
(31)
- Negative welding potential at the
(-)current socket
8
soft, low-spatter arc