Mount The Handle Piece To The Power Source - GT Trans Pocket 4000 CEL Mode D'emploi

Mount the power
source on the
trolley
(continued)
Fig.19 Straighten and fix the catches
Mount the handle
piece to the
power source
Fig.20 Slot the handle plates into place
(10)
(10)
Fig.22 Fix the handle plates and handle tube with
3.
4.
(4)
(3)
(1) (2) (2)
NOTE! When fitting the two handle plates together (1), make sure that the
catches (2) on the underside of the handle plates (1) slot completely into place
(Fig.16 and Fig.17)
(3) (4) (1) (5)
(9)
(9)
"Extrude-Tite" screws
Fix the handle plates (1) to one another at the top using four Extrude-Tite screws (5)
and (7)
NOTE! When fixing the two handle plates (1) in the middle, insert two Extrude-
Tite screws (9) from one side and two Extrude-Tite screws (10) from the other
side, so that in each case the heads of the screws are on the side with the
larger borehole.
Fix the handle plates (1) to one another in the middle using four Extrude-Tite screws
(9) and (10)
7.
(4)
8.
9.
(3) (3)
(1) (2)
(2)
Fig.21 Handle plates and handle tube
1.
(6) (7) (8)
2.
16
Straighten the catches by moving
each of the outermost threaded bolts
(4) as far as it will go
Tighten the six wing nuts (3)
Carefully place the trolley, complete
with the power source, down onto its
wheels
(3)
(1)
On the handle (4) of the power sour-
ce, use the catches (2) to slot the
handle plates (1) into one another
(Fig.20 and Fig.21)
Insert the cotter pin (8) of the handle
tube (3) into the guides (6) of both
handle plates
NOTE! When fixing the two
handle plates (1) at the top, insert
two Extrude-Tite screws (5) from
one side and two Extrude-Tite
screws (7) from the other side, so
that in each case the heads of the
screws are on the side with the
larger borehole.
(1)