Mounting The "Everywhere" Trolley; General Remarks; Mount The Power Source On The Trolley - GT Trans Pocket 4000 CEL Mode D'emploi

Mounting the "Everywhere" trolley

General remarks

Mount the power
source on the
trolley
Fig.16 Insert the catches
Fig.17 Power source and trolley
Fig.18 Put on washers and wing nuts
WARNING! An electric shock can be fatal. If the machine is plugged into the
mains electricity supply during installation, there is a high risk of very serious
injury and damage. Only carry out work on the machine when
-the mains switch is in the - O - position,
-the machine is unplugged from the mains.
(1) (1)
X
(2) (3) (2) (3)
15
1. Insert the catches (1) into the boreho-
les on the base of the trolley
2. Angle the catches (1) obliquely as far
as they will go
NOTE! When placing the power
source up on end, make sure that
you do not kink or pinch the
mains cable, or subject it to
tensile strain.
3. Carefully place the power source up
on end
4. Carefully place the trolley up on end
5. Push the trolley up against the power
source so that the trolley and the
power source are exactly facing one
another
6. Push washers (2) onto the six threa-
ded bolts and slightly tighten the wing
nuts (3)
(2) (3)