Tp 08 Remote-Control Unit - GT Trans Pocket 4000 CEL Mode D'emploi

TR 1000 / TR 1100
remote-control
unit
(continued)
Fig.11 TR 1000 / TR 1100 control panel
TP 08 remote- System requirements:
control unit -
Fig.12 TP 08 remote-control unit
If the TP 08 remote-control unit has been connected up since the power source was last
switched on, it is only possible to set the amperage and arc-force dynamic on the TP 08
remote-control unit.
To make it possible to set the amperage and the arc-force dynamic from the power
source once again, as well as from other system add-ons:
-
-
(38) (37)
(39)
Software version 2.81.1
(ZO) (ZP) (ZQ)
(ZM)
(ZL)
NOTE! The welding voltage is switched to the welding sockets after a 3 sec
time-lag. The TP 08 remote-control unit is then supplied with welding voltage,
and indicator (ZM) lights up.
Disconnect the TP 08
Switch off the power source, then switch it back on again
(37) Parameter-display button(s) ... for
(38) (37)
(38) Parameter-setting button(s) ... for
(39) Welding current parameter
1.
(ZN)
(ZR)
2.
3.
(ZL)
10
selecting the parameter to be display-
ed (welding current, ...)
altering the selected parameter
With the "Process" button (3), select
the rod-electrode (MMA) welding
process
Attach the earth clamp to the workpi-
ece and clamp the electrode holder to
the TP 08 remote-control unit
Place the TP 08 down on the workpi-
ece in such a way that there is a solid,
firm connection between the workpi-
ece and the two contacts (ZL)