Connections; Tp 4000 Cel / Tp 5000 Cel Power Source - GT Trans Pocket 4000 CEL Mode D'emploi

Connections

TP 4000 CEL / TP
5000 CEL power
source
F ig.3 Front and rear view of TP 4000 CEL / TP
(C) Blanking cover
(D) Blanking cover
(E) Blanking cover (intended for LocalNet connection socket)
(F) Blanking cover (intended for LocalNet connection socket)
(G) Mains cable with strain-relief device
TR 2000 remote
control unit
(24)
(25)
Fig.4
(E) (F)
(A) (B) (C) (D)
5000 CEL power source
NOTE! If the remote-control TR 3000 is used, always connect the rod electrode
cable to the (+) current socket.
TR 2000 remote control unit
(A) (-)-Current socket with bayonet
latch ... for
- connecting rod electrode or the
earth cable in manual electrode
welding (depending on electrode
type being used)
- current connection for TIG welding
torch
(B) (+)-Current socket with bayonet
latch ... for
- connecting for rod electrode or earth
cable in manual electrode welding
(G)
(depending on electrode type being
used)
- connecting the earth cable in TIG
welding
(24) Welding current setting dial ... for
selecting the welding current
(25) Arc-force setting dial
Manual electrode welding..for influen-
cing the short-circuiting amperage at
the instant of droplet transfer
0
100
NOTE! Parameters that can be
set on the remote-control unit
cannot be changed on the power
source. Parameter changes can
only be made on the remote-
control unit.
7
soft. low-spatter arc
harder, more stable arc