Option Tig-Comfort-Stop - GT Trans Pocket 4000 CEL Mode D'emploi

Option TIG- Important! The activation and the setting of the optional TIG-Comfort-Stop function is
Comfort-Stop carried out by means of the CSS parameter. The CSS parameter is included in the
"Setup-Menu - Level 2".
Fig.29 TIG-Comfort-Stop
1.
2.
3.
4.
5.
Fig.30 TIG-welding process with activated TIG-Comfort-Stop option
1.
Welding
During welding, uplift welding torch: the arc is increased significantly
Lower torch:
- Arc is reduced significantly
- TIG-Comfort-Stop function triggered
Keep torch level
- Welding current is decreased continuously (downslope)
- the arc extinguishes
Wait the gas post-flow time and remove torch from the component
I
gas pre-flow
2.
set welding current
24
3. 4.
gas
downslope
post-flow
t