GT Trans Pocket 4000 CEL Mode D'emploi page 79

TP 08 remote- (ZN) Parameter selection button ... For selecting the parameters
control unit
(continued)
(ZQ) (+) button ... Increases the value for the selected parameter
(ZR) (-) button ... Decreases the value for the selected parameter
Service-Code: -OFF-
Cause:
Remedy:
Service-Code: -E62-
Cause:
Remedy:
As long as a service code is displayed on the power source or any other system add-on,
the TP 08 remote-control unit is out of action.
- Welding current (ZO)
- Arc-force dynamic (ZP)
NOTE! Irrespective of the service codes given in the "Troubleshooting" section,
the following service codes may be displayed on the TP 08 remote-control unit:
Poor contact with the workpiece
Create a solid, firm connec-tion to the workpiece
Overtemperature on the TP 08 r.-c. unit
Allow the TP 08 to cool down
11