Bushnell Trophy Cam HD Notice D'utilisation page 44

2. Screen comes on but then powers off
Make sure that you have installed the SD card correctly.
Camera won't retain settings
Make sure that you have been saving the changes to any parameter
settings that you made while in Setup mode, by pressing "OK" after
changing the setting. If you don't save your new setting after changing
it, the camera will continue to use the original default setting for that
parameter.
Moisture or Ants Inside Camera
1. To ensure humidity or rain is kept out of the camera, secure the DC In
plug firmly in place.
2. Ants can be attracted by low level electronic vibrations, and enter
through any gaps between the exterior and interior of the camera.
Make sure the DC In plug is securely attached.
Field Scan (Time Lapse) not working properly
1. Make sure that the stop and start times of Field Scan "A" and "B" do
not overlap (for example, do not set the start time of "B" to 8AM if the
stop time of "A" is 10AM).
2. When using Field Scan in video mode, the smallest interval time avail-
able is 5 min, to avoid potential overheating of the batteries and elec-
tronic components, which could cause operational failure or damage to
the camera. In still photo mode, a 1 min. Interval can be set.
Do not mix battery types-use ALL lithium or ALL alkaline.
Rechargeable batteries are not recommended.
44
Do not mix old and new batteries.