Bushnell Trophy Cam HD Notice D'utilisation page 15

USING THE SETUP MENU TO CHANGE SETTINGS
The main purpose of the SETUP mode is to allow you to change the
settings of the camera's parameters (22 different ones are available!) so your
WIRELESS Trophy Cam HD operates exactly the way you want it to. You
will do this by entering the SETUP Menu and pressing the keys below the
LCD display, which will show you each parameter and its setting.
Changing Parameter Settings in SETUP Mode
A wide range of options or "parameters" are provided to allow you to set the
WIRELESS Trophy Cam HD to your operational preferences. To change
the setting of any parameter you must first switch to the SETUP mode.
Once in SETUP mode, pressing the MENU button will allow you to select
any parameter and change its setting. The name of the parameter and its
current setting will be shown on the LCD. Pressing the RIGHT or LEFT
key scrolls to the next or previous parameter (RIGHT key to move on to
the next parameter and LEFT key to go back to the previous parameter),
and pressing the UP or DOWN key lets you select a different setting for
the currently displayed parameter. Once you have selected your preferred
new setting for a parameter, press the OK button to save the new setting
(actually change it). When you are finished changing the settings of one or
more parameters, press MENU again to exit the SETUP menu. MENU can
also be pressed anytime you want to cancel changing a parameter's setting
after a new setting has been selected (but OK has not been pressed yet).
After setting the parameters to your preferences, be sure to move the switch
to ON to begin actually taking photos or videos. No images will be captured
if the switch is left in the SETUP position (unless you press the RIGHT/Shot
key after exiting the menu)-in fact, the camera will power off automatically after
a few minutes with no key pressed.
Parameter Settings Display
The settings for each parameter are shown on the display screen of your
WIRELESS Trophy Cam HD. All the available settings for the currently
displayed parameter are shown on one screen, with a checkmark next
to the current setting (Pg. 16, Fig. 4a). To change the setting, first use the
UP/DOWN keys to highlight (select) the new setting you want (Fig. 4b),
then press OK to "Execute" the actual change to the selected setting.
The checkmark will appear next to your new setting to confirm this
(Fig. 4c).
15