Loading Batteries - Bushnell Trophy Cam HD Notice D'utilisation

INSTALLING THE BATTERIES AND SD CARD
Before you begin learning how to use your WIRELESS Trophy Cam HD,
you will first need to install a set of batteries and insert an SD card. Although
that may only take you a minute, there are some important notes about both
batteries and SD cards you should be aware of, so please take the time to
read the following directions and cautions:

Loading Batteries

After opening the two latches on the right side of the
WIRELESS Trophy Cam HD, you will see that the
WIRELESS Trophy Cam HD has twelve battery
slots. For maximum battery life, you should install a full
set of batteries. The WIRELESS Trophy Cam HD
may also be operated by just four batteries installed
in the first slots only (starting on the left-see photo).
Battery life will be shorter with 4 batteries, but the
camera will operate normally. Whether you use 4 or
a full set, be sure to insert each battery with correct
polarity (negative or "flat" end against the long spring
of each battery slot).
Bushnell recommends using a full set of new lithium
AA (Energizer brand) or alkaline AA batteries. NiMh
®
Rechargeable batteries are not recommended, as the
lower voltage they produce can cause operational
issues.
When the camera's internal (AA) batteries become weak, the low-battery
indicator LED will glow blue, indicating the camera's batteries should be
changed (pg 9, Front View).
Optionally, you can connect the #119656C Accessory Solar Panel
(please visit www.bushnell.com for more information) to the "DC In" jack
at the bottom of the WIRELESS Trophy Cam HD (other external power
supplies should not be used, as the camera and/or display may not function
correctly). If the solar panel is connected and AA batteries are installed,
the WIRELESS Trophy Cam HD will be powered by the solar panel's
rechargeable lith-ion battery, as long as it provides adequate voltage (if not,
10